On A Desk; On A Wall Or Wall Plate - Radio Shack TAD-705 Owner's Manual

43-705.fm Page 8 Tuesday, May 23, 2000 8:54 AM
• Always connect the AC adapter to the
TAD before you connect it to AC power.
When you finish, disconnect the adapter
from AC power before you disconnect it
from the TAD.

On a Desk

1. Plug one end of the supplied long modu-
lar cord into the
TEL. LINE
back of the TAD, then plug the cord's
other end into a modular phone line
jack.
2. Plug the supplied AC adapter's barrel
plug into the
AC 9V 400mA
back of the TAD, then plug the other end
of the adapter into a standard AC outlet.
When you first connect power, the TAD
beeps once, MEMORY TEST
the message counter counts up from
22 . Then the TAD beeps.
appears. OGM1 and OGM2 flash to
SAGE
indicate that no outgoing messages are re-
corded.

On a Wall or Wall Plate

Note: To mount the TAD directly on a wall,
you need two screws (not supplied) with
heads that fit the keyhole slots on the mount-
ing bracket. Drill two holes 3
mm) apart. Then thread a screw into each
hole, letting the heads extend about
(5 mm) from the wall.
8
1. Plug the supplied short modular line
2. Insert the supplied AC adapter's barrel
3. To mount the TAD on a wall plate , route
jack on the
jack on the
appears, and
to
0
0 CALL 0 MES-
4. Slide the handset clip out of its retaining
5. Plug one end of the supplied coiled
15
/ inches (100
16
3
/ inch
16
Preparation
cord into the TEL.LINE jack on the back
of the TAD.
plug into the AC 9V 400 mA
back of the base.
the adapter cord hanging down and the
other end of the short modular cord
through the center of the bracket. Insert
the tabs on the narrow end of the
bracket into the slots on the bottom of
the base, then push the tab on the wide
end of the bracket into the lower slots on
the bottom of the base.
Plug the short modular cord's other end
into the wall plate jack, align the base's
keyhole slots with the wall plate studs,
and slide the base downward to secure
it.
To mount the TAD directly on a wall , with
the power cord and the long modular
cords hanging down, insert the tabs on
the narrow end of the bracket into the
slots on the bottom of the base then
push the tab on the wide end of the
bracket into the lower slot on the bottom
of the base.
Align the TAD's keyhole slots with
screws and slide the TAD down to
secure it, then plug the modular cord
into a modular phone line jack.
slot, rotate it 180° then slide it back into
its slot.
handset cord into the jack on the left
side of the base. Plug the other end into
the handset's jack. Then place the hand-
set on the base.
jack on the