Setting The Day, Time And Date; Setting The Number Of Rings - Radio Shack TAD-705 Owner's Manual

43-705.fm Page 10 Tuesday, May 23, 2000 8:54 AM
2. Press twice. 000
DIAL
CODE appear. The first
: : : :
3. Repeatedly press
digit of your area code appears, then
9 9 9 9 ; ; ; ;
press / to the second digit. The
second 0 flashes.
Note: If you make a mistake, repeatedly
9 9 9 9 ; ; ; ;
press / to move the cursor to the
position of the incorrect digit then re-
enter the code.
4. Repeat Step 3 to set the second and
third digits of your area code.
5. Press then press
DIAL
the time display.
SETTING THE DAY, TIME
AND DATE
To avoid losing the day and time settings if
AC power fails, we recommend you install a
backup battery before you set the day and
time (see "Installing a Backup Battery" on
Page 7).
Follow these steps so the TAD can record
the correct day and time each message and
memo is recorded.
Note: If you do not complete each step with-
in 8 seconds, the TAD exits setup. Start
again at Step 1.
1. Hold down until the TAD beeps
STOP
once.
2. Repeatedly press
DIAL
appears.
: : : :
3. Repeatedly press
.
PM
9 9 9 9 ; ; ; ;
4. Press / . The hour digit flashes.
: : : :
5. Repeatedly press
rect hour.
10
and SET AREA
0 flashes.
8 8 8 8
/ until the first
SETTING THE NUMBER OF
RINGS
Set the ring select switch to
Saver) to set how long the TAD waits before
it answers a call (2 rings, 4 rings, 7 rings or
toll-saver).
to return to
STOP
If you plan to check your messages by long
distance, set the ring select switch to
until
SUNDAY
8 8 8 8
/ to select AM or
8 8 8 8
/ to set the cor-
Preparation
6. Repeat Steps 4 and 5 to set the minute,
month, date, and the day of the week.
7. Press then press
DIAL
the time display.
to return to
STOP
, , , or (Toll
2 4 7 TS
.
TS