Manually Assigning Track Numbers; Setting The Recording Level; Finalizing; Erasing Or Unfinalizing A Cd-Rw - Radio Shack CD Player User Manual

Note: Every time recording is paused or
stopped, a new track number is always
assigned.
8. Press D to stop recording.
Manually Assigning Track
Numbers
It is possible to assign track numbers while
recording. While recording, press
The current track number is incremented by
one.

Setting the Recording Level

Play the source to be recorded, and press
– or + to adjust the
DIGITAL REC LEVEL
recording level (± 6 dB). The loudest sound
should not exceed the 0 dB of the peak level
meter.
Unlike analog equipment, digital audio units
produce extremely unpleasant sounds when
distorted, and there is no "headroom" after
the 0 mark. When you record digitally from
a commercially-produced CD, set the digital
volume to 0 dB. This will maintain all the
dynamic range of the source CD without
clipping. Only boost the signal if the source
is exceptionally quiet.
Notes:
• Recording level is set to 0 dB when the
power is turned on.
• You can only change the recording level
when the CD recorder is in the stop
mode or when the CD recorder plays
the PLAYBACK tray.
24

Finalizing

As explained earlier, in order for a disc to
become a standard CD, it must have a Table
of Contents (TOC) written to it. This
process is known as finalizing. Once
finalized, CD-R discs are truly final. You
cannot record any more tracks on them. By
contrast, you can "unfinalize" CD-RW discs
and record more tracks on them.
.
RECORD
1. Load an unfinalized (recordable) disc in
the RECORD/PLAYBACK tray.
appears if the disc is unfinalized.
2. Press
cancel the finalizing process, press D .
3. Press g /
FINALIZE
When the operation is finished, the display
returns to the track/time display.
disappears.
Notes:
• During finalizing, never turn the power
off or unplug the power cord.
• Although finalized CD-R discs may be
replayed on ordinary CD players,
finalized CD-RW discs may not play on
ordinary CD players.

Erasing or Unfinalizing a CD-RW

If a CD-RW is finalized, you can unfinalize it
or erase all tracks on it. If a CD-RW is not
finalized, you can erase the last track on it or
erase all tracks on it. Remember that it is not
possible to perform any erase procedures on
a CD-R disc.
in the stop mode. To
FINALIZE
to start finalizing.
ENTER
scrolls on the display.
NO TOC
NO TOC