Konica Minolta CM-25cG Instruction Manual page 121

Caution: The setting or operation is not correct.
The reflectance is outside the range of guaranteed performance.
The gloss value is outside the range of guaranteed performance.
Check the USB connection.
The target is protected.
The date is incorrect.
The set tolerance range is incorrect. Please check the upper and lower limits.
Please retry the measurement.
Press the measurement button to measure and update to the most recent data.
The data could not be calculated.
The input data is incorrect.
No target was found.
No data exists.
Only administrators can control this function.
Display: The flow of operation is displayed. Perform the operation according to the information displayed.
Perform zero calibration.
Please set the instrument on the zero calibration box and calibrate.
Perform white calibration.
Please set the instrument on the white calibration plate and calibrate.
Configure the white calibration data.
Perform gloss calibration.
Please set the instrument on the gloss calibration plate and calibrate.
Configure the gloss calibration data.
Please close the viewfinder.
Specify at least one.
Calibration is required. Would you like to calibrate now?
The device memory is full. Please delete some data to measure.
Perform user calibration.
Please set the instrument on the user calibration plate and calibrate.
Configure the user calibration data.
Data is being saved. Please wait until the power turns off.
Data is being processed. Please wait.
Regularly scheduled device calibration is required. Please contact the nearest service center.
Regularly scheduled device calibration is approaching. Please contact the nearest service center.
Calibration is recommended. Would you like to calibrate now?
P.97
P.59
P.91
P.62, 66
P.88
P.32
P.32
P.34
P.34
P.34
P.35
P.35
P.34
P.37
5
P.32
P.38, 45
P.36
P.36
P.36
P.111
P.111
P.32, 110
118