HP ProCurve 2910al Access Security Manual page 339

< any | host < SA > | SA < mask | SA/mask-length >>
Defines the source IPv4 address (SA) a packet must carry for
a match with the ACE.
• any — Allows IPv4 packets from any SA.
• host < SA > — Specifies only packets having < SA > as the
source. Use this criterion when you want to match only the
IPv4 packets from a single SA.
• SA < mask > or SA /mask-length — Specifies packets received
from an SA, where the SA is either a subnet or a group of
IPv4 addresses. The mask format can be in either dotted-
decimal format or CIDR format (number of significant
bits). (Refer to "Using CIDR Notation To Enter the IPv4 ACL
Mask" on page 9-43).
SA Mask Application: The mask is applied to the SA in the
ACE to define which bits in a packet's SA must exactly match
the SA configured in the ACL and which bits need not match.
Example: 10.10.10.1/24 and 10.10.10.1 0.0.0.255 both define
any address in the range of 10.10.10.(1 - 255).
Note: Specifying a group of contiguous addresses may
require more than one ACE. For more on how masks operate
in ACLs, refer to "How an ACE Uses a Mask To Screen Packets
for Matches" on page 9-28.
IPv4 Access Control Lists (ACLs)
Configuring Standard ACLs
9-51