Configuring A Remote Pc To Network Vpn; Sample Pc To Network Vpn Tunnel Configuration Worksheet - NETGEAR FVM318 Reference Manual

Reference Manual for the Model FVM318 Cable/DSL ProSafe Wireless VPN Security Firewall

Configuring a Remote PC to Network VPN

This procedure describes linking a remote PC and a LAN. The LAN will connect to the Internet
using an FVS318 with a fixed IP address. The PC can be connected to the Internet through dialup,
cable or DSL modem, or other means, and we will assume it has a dynamically assigned IP
address.
The PC must have a VPN client program that supports IPSec. NETGEAR recommends and
supports the SafeNet SoftRemote (or Soft-PK) Secure VPN Client for Windows, Version 5 or later.
The SafeNet VPN Client can be purchased from SafeNet at http://www.safenet-inc.com.

Sample PC to Network VPN Tunnel Configuration Worksheet

The sample configuration worksheet below is filled in with the parameters used in the procedure
examples below. A blank worksheet is at,
Configuration Worksheet" on page
Table 4-2: Sample PC to Network IKE VPN Tunnel Settings Configuration Worksheet
IKE Tunnel Security Association Settings
Connection Name:
PreShared Key
Secure Association -- Main Mode or Aggressive Mode:
Perfect Forward Secrecy:
Encryption Protocol -- Null,
Key Life in seconds:
IKE Life Time in seconds:
FVM318 firewall
Network and PC IP Settings
LAN A
Network:
Computer: PC
4-12
"PC to Network IKE VPN Tunnel Settings
4-27.
:
56 bit DES, or 168 bit 3DES:
Local IPSec
Identifier Network Address
LANAPCIPSEC 192.168.3.1
192.168.100.2
PCIPSEC
LAN IP
Subnet Mask
255.255.255.0
255.255.255.255
VPNLANPC
r>T(h4&3@#kB
Main
Enabled
DES
(1 hour)
3600
(8 hours)
28800
Gateway IP
(WAN IP Address)
24.0.0.1
0.0.0.0
Virtual Private Networking