Status Lights; Cycles - Whirlpool cabrio W10164751A Use & Care Manual

Status Lights; Cycles - Whirlpool Cabrio W10164752A Use & Care Manual [Page 17]
Cycle tips
Dry most loads using the preset cycle settings.
Refer to the Automatic or Timed Preset Cycle Settings chart (in
the "Cycles" section) for a guide to drying various loads.
Drying temperature and dryness level are preset when you
choose an Automatic Cycle. You can select a different
dryness level, depending on your load, by pressing Dryness
and choosing More, Normal, Less, or Damp.
NOTE: You cannot use the Time Adjust and you cannot
choose a Temperature with the Automatic Cycles.
If you wish to adjust the cycle length of a Timed Cycle, press
the Time Adjust up or down arrows. Adjust the temperature
of a Timed Cycle by pressing Temp until the desired
temperature is selected.
NOTE: You cannot choose a dryness level with Timed

Cycles.

Follow the progress of your dryer with the drying Status indicator
lights.
Sensing
In an Automatic Cycle, the Sensing light illuminates until a wet
item is detected.
In the Timed Cycle, the Sensing light illuminates at the beginning
of a cycle and turns off 5 minutes into the cycle.
Wet
The Wet light illuminates at the beginning of an Automatic Cycle if a
wet item is detected.
In an Automatic Cycle, if a wet item is not detected after
approximately 5 minutes, the dryer goes directly into Cool Down
and the Cool Down and the WRINKLE SHIELD™ setting
indicators illuminate, if selected.
In a Timed Cycle, wet items are not detected. The dryer will
continue to run for the length of time selected, and the Wet light
will illuminate. The damp light will not illuminate.
//static-data2.manualslib.com/manual/190510/Whirlpool-Cabrio-W10164752a.html?page=17 (2 of 7)3/24/2018 10:31:33 PM

Status Lights

Indicator lights
Other indicator lights show Cycle, Modifiers, Options, and Cycle
Signal settings selected. The display shows the estimated or actual
time remaining.
Cycles
Select the drying cycle that matches the type of load you are drying.
See the Automatic, Steam, or Timed Preset Cycle Settings Charts.
Automatic Cycles
Automatic Cycles allow you to match the cycle to the load you are
drying. See the following Automatic Preset Cycle Settings chart.
Each cycle dries certain fabrics at the recommended temperature. A
sensor detects the moisture in the load and automatically adjusts
the drying time for optimal drying.
Heavy Duty
Use this cycle to get high heat for heavyweight mixed loads,
cottons, and jeans.
Normal
Use this cycle to get medium heat for drying sturdy fabrics such as
work clothes.
Casual
Use this cycle to get low heat for drying no-iron fabrics, such as
sport shirts, casual business, clothes, and permanent press blends.
Delicate