Table of Contents
Advertisement
Installation Instructions; Tools And Parts; Location Requirements - Whirlpool Cabrio W10164752A Use & Care Manual [Page 5]
WARNING: Gas leaks cannot always be detected by smell.
Gas suppliers recommend that you use a gas detector approved by UL or CSA.
For more information, contact your gas supplier.
If a gas leak is detected, follow the "What to do if you smell gas" instructions.
In the State of Massachusetts, the following installation instructions apply:
Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
If using a ball valve, it shall be a T-handle type.
A flexible gas connector, when used, must not exceed 3 feet.
Gather the required tools and parts before starting installation. Read
and follow the instructions provided with any tools listed here.
8" or 10" pipe wrench
8" or 10" adjustable wrench
(for gas connections)
Flat-blade screwdriver
Adjustable wrench that
opens to 1" (25 mm) or hex-
head socket wrench (for
//static-data2.manualslib.com/manual/190510/Whirlpool-Cabrio-W10164752a.html?page=5 (2 of 7)3/20/2018 3:41:03 AM
INSTALLATION INSTRUCTIONS
Tools and Parts
¼" nut driver or socket
wrench
Knife
Vent clamps
Pipe-joint compound
resistant to LP gas
Caulking gun and compound
Parts needed:
Check local codes and consult gas supplier. Check existing gas
supply, electrical supply, and venting, and read "Electrical
Requirements," "Gas Supply Requirements," and "Venting
Requirements" before purchasing parts.
Mobile home installations require special parts (listed following) that
may be ordered by calling the dealer from whom you purchased
your dryer. For information on ordering, please refer to the
"Assistance or Service" section. You may also contact the dealer
from whom you purchased your dryer.
Mobile home installation kit. Ask for Part Number 346764.
Metal exhaust system hardware.
Advertisement
Table of Contents
