Whirlpool cabrio W10164751A Use & Care Manual page 5

WHIRLPOOL CABRIO W10164752A USE & CARE MANUAL Pdf Download.
Page 4
IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or the Canadian Natural Gas and Propane Installation Code, CSA B149.1. The dryer must
be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.
Page 5: Installation Instructions, Tools And Parts, Location Requirements
WARNING: Gas leaks cannot always be detected by smell. Gas suppliers recommend that you use a gas detector approved by UL or CSA. For more information, contact your gas supplier. If a gas leak is detected, follow the "What to do if you
smell gas" instructions. In the State of Massachusetts, the following installation instructions apply: ...
Page 6: Electrical Requirements
A grounded electrical outlet located within 2 ft (610 mm) of either side of the dryer. See "Electrical Requirements."
should also be considered.
Page 7: Gas Supply Requirements
It is also recommended that a separate circuit serving only this dryer be provided. GROUNDING INSTRUCTIONS
reduce the risk of electric shock by providing a path of least resistance for electric current.
Page 8: Venting Requirements
4" (102 mm) heavy metal exhaust vent and clamps must be used. DURASAFE™ venting products are recommended. DURASAFE™ vent products can be purchased from your dealer or by calling Whirlpool Parts and Accessories. For more 2"
information, see the "Assistance or Service" section.
Page 9: Plan Vent System
Exhaust Recommended hood styles are shown here. 4" (102 mm) 4" (102 mm) A. Louvered hood style B. Box hood style The angled hood style (shown here) is acceptable. 4" (102 mm) 2½" (64 mm)
keep rodents and insects from entering the home.
Page 10: Install Vent System, Install Leveling Legs, Make Gas Connection
Determine vent path Select the route that will provide the straightest and most direct path outdoors.
Page 11: Connect Vent, Connect Inlet Hose
A combination of pipe fittings must be used to connect the dryer to the existing gas line. Shown is a recommended connection. Your connection may be different, according to the supply line type, size, and location. " flexible gas connector "...
Page 12: Level Dryer, Reverse Door Swing
Level Dryer Check the levelness of the dryer by first placing a level on the top of the dryer near the console. Then, by placing a level in the crease on the side of the dryer between the top of the dryer and the dryer cabinet, check the levelness from
front to back.
Page 13: Complete Installation
Reverse the strike 1. Remove the door strike from the dryer door opening. 2. Remove the cosmetic screw opposite the door strike. A. Door strike B. Cosmetic screw 3. Reinstall the door strike and cosmetic screw on the opposite side of the dryer
door opening from where they were removed.
//static-data2.manualslib.com/manual/190510/Whirlpool-Cabrio-W10164752a.html (5 of 11)3/20/2018 3:36:55 AM
A sturdy floor to support the total weight (dryer and load) of 200 lbs (90.7 kg). The combined weight of a companion appliance
For a grounded, cord-connected dryer: This dryer must be grounded. In the event of malfunction or breakdown, grounding will
Plan the installation to use the fewest number of elbows and turns.
An exhaust hood should cap the vent to
When using elbows or making turns, allow as much room as possible.