Lexus NX300h Owner's Manual page 300

300
5-5. Using the other interior features
within 60 seconds, otherwise the indi-
cator light will stop flashing and pro-
gramming will not be able to be
completed.
1
Press and release the HomeLink
button you want to program and
check that the HomeLink
tor light flashes orange.
2
Point the remote control transmit-
ter for the device at the rear view
mirror, 1 to 3 in. (25 to 75 mm)
from the HomeLink
Keep the HomeLink
view while programming.
3
Program a device.
Programming a device other than

an entry gate (for U.S.A. owners)
Press and hold the remote control trans-
mitter button until the HomeLink
tor light changes from slowly flashing
orange to rapidly flashing green (rolling
code) or continuously lit green (fixed
code), then release the button.
LEXUS NX300h
al_USA_OM78212U
®
®
indica-
®
buttons.
®
indicator light in
®
indica-
Owners Manu-
Programming an entry gate (for

U.S.A. owners)/Programming a
device in the Canadian market
Press and release the remote control trans-
mitter button at 2 second intervals, repeat-
®
edly, until the HomeLink
changes from slowly flashing orange to
rapidly flashing green (rolling code) or
continuously lit green (fixed code).
®
4 Test the HomeLink
pressing the newly programmed
button and observing the indicator
light:
 Indicator light illuminates: Program-
ming of a fixed code device has
completed. The garage door or
other device should operate when a
®
HomeLink button is pressed and
released.
 Indicator light flashes rapidly: The
garage door opener motor or other
device is equipped with a rolling
code. To complete programming,
firmly press and hold the Home-
®
Link button for 2 seconds then
release it.
 If the garage door or other device
does not operate, proceed to "Pro-
gramming a rolling code system".
indicator light
operation by