Lexus NX300h Owner's Manual page 147

Tilting up and down
■
1
Tilt up
Press and hold the "UP" switch. It automat-
ically opens until the tilt up stop position.
2
Tilt down
Press and hold the "DOWN" switch. The
moon roof full close automatically.
*
: Lightly press either end of the moon roof
switch to stop the moon roof while it is
operating.
The moon roof can be operated when
■
The power switch is in ON mode.
Jam protection function
■
If an object is detected between the moon
roof and the frame while the moon roof is
closing or tilting down, travel is stopped and
the moon roof opens slightly.
Sunshade
■
The sunshade can be opened and closed
manually. However, the sunshade will open
automatically when the moon roof is
opened.
When the moon roof does not close nor-
■
mally
Perform the following procedure:
● If the moon roof closes but then re-opens
slightly
1 Stop the vehicle.
2 Press and hold the "CLOSE" switch.
The moon roof will close, reopen and pause
for approximately 10 seconds.
Then it will close again and tilt down. Finally
it will stop.
LEXUS NX300h
al_USA_OM78212U
3-5. Opening, closing the windows and moon roof
*
*
*1
*2
Owners Manu-
3 Check to make sure that the moon roof
completely stops and then release the
switch.
● If the moon roof tilts down but then tilts
back up
1
Stop the vehicle.
2 Press and hold the "DOWN" switch.
The moon roof will close, reopen and pause
for approximately 10 seconds in the tilt up
*2
position.
Then it will close again. Finally it will stop.
3
Check to make sure that the moon roof
has completely stopped and then
release the switch.
*1
: If the switch is released at the incorrect
time, the procedure will have to be per-
formed again from the beginning.
*2
: If the switch is released after the above
mentioned 10 second pause, automatic
operation will be disabled. In that case,
perform the moon roof initialization by
referring to "When tilt up/down or moon
roof opening and closing can be done
but automatic full opening and closing
cannot be done" on P.147.
If the moon roof does not fully close even
after performing the above procedure cor-
rectly, have the vehicle inspected by your
Lexus dealer.
When the moon roof does not move
■
normally
When the opening and closing operation or
automatic opening function of the moon
roof does not move normally, perform the
following initialization procedures.
1 Turn the power switch to ON mode.
2 Operate the moon roof.
The initialization method changes depend-
ing on the contents that can be operated.
If only the tilt up operations can be done
●
when the moon roof is closed
3 Press and hold the "DOWN" or
"CLOSE" switch.
Open until the tilt up stop position. After
that the moon roof opens and completely
closes.
147
*1
3