ActionTec GT724-WG User Manual page 6

Power Light
The Power light displays the Gateway's current status. If the Power light glows steadily green, the
Gateway is receiving power and fully operational. When the Power light flashes rapidly, the Gateway is
initializing. If the Power light is not illuminated when the Power cord is plugged in and the Power switch
is turned on, the Gateway has suffered a critical error and technical support should be contacted.
DSL Light
The light illuminates when the Gateway is connected to a
DSL
it flashes, the Gateway's built-in
5 Chapter 1 Introduction
Internet Light
When the Internet light glows steadily, the Gateway is connected to the
Ethernet Lights
The Ethernet lights illuminate when the Gateway is connected via one or more of its Ethernet ports.
USB Light
The light illuminates when the Gateway is connected via its
USB
Wireless Light
The Wireless light illuminates when the Gateway is activated for wireless use.
Rear Panel
The rear panel of the Gateway contains seven ports (Ethernet [4], Phone,
and Power switches.
Phone Port
The Phone port is used to connect the Gateway to a
6 Actiontec 54 Mbps Wireless DSL Gateway User Manual
USB Port
The port is used to connect a computer to the Gateway via
USB
Ethernet Ports
The Ethernet ports are used to connect computers to the Gateway via Ethernet cable. The Ethernet ports
are Mbps auto-sensing ports, and either a straight-through or crossover Ethernet cable can be used
10/100
when connecting to the ports.
Reset Switch
Depressing the Reset switch for one or two seconds will power cycle the Gateway (similar to unplugging
and then plugging in the Gateway's Power cord). To restore the Gateway's factory default settings,
depress and hold the Reset switch for approximately 10 seconds. The reset process will start about
seconds after releasing the switch.
PowerDSLInternet
EthernetUSBWireless 1
PowerDSLInternetEthernet Wireless
modem is training for
DSL
PowerUSBEthernet 4ResetPhoneEthernet 3Ethernet 2Ethernet 1
connection.
DSL
234 1234
USB
(Digital Subscriber Line) line. When
DSL
service.
DSL
provider.
DSL
port.
USB
, and Power), as well as Reset
USB
cable.
USB
10
6