Dynamic Routing; Nat (Network Address Translation); Static Routing; Upnp (Universal Plug And Play) - ActionTec GT724-WG User Manual

Medium
If Medium is selected in the "Firewall Security Level" screen, the services listed at the bottom of the
screen ( , ,
HTTP FTP POP3
allowed to pass through the firewall. Additionally, the user can click in the appropriate check box to allow
or deny access for a particular service (check mark in the check box to allow; blank check box to deny). All
services not listed are denied access.
Low
If Low is selected in the "Firewall Security Level" screen, the services listed at the bottom of the screen
( , ,
NETBIOS-SSN DNS EPMAP
and ,) are blocked by the firewall. Additionally, the user can click in the appropriate check
MICROSOFT-GC
box to allow or deny access for a particular service (check mark in the check box to allow; blank check box
to deny). All services not listed are denied access.
51 Chapter 4 Using Advanced Setup
Off
If Off is selected in the "Firewall Security Level" screen, firewall filtering is based solely on the basic
firewall.

Dynamic Routing

Selecting Dynamic Routing in the "Configuring the Advanced Settings" screen generates the "Dynamic
Routing" screen.
If another router or gateway is set up behind the Gateway in the network configuration, consult the
documentation that came with the other router/gateway to see what kind of Dynamic Routing is required
operate it with the Gateway, then select the appropriate option.
52 Actiontec 54 Mbps Wireless DSL Gateway User Manual

NAT (Network Address Translation)

Selecting in the "Configuring the Advanced Settings" screen generates the "
NAT
Gateway's basic firewall security is based on
Gateway to be accessed by outside parties. Do not turn

Static Routing

Selecting Static Routing in the "Configuring the Advanced Settings" screen generates the "Static Routing"
screen. Enter the addresses in their respective text boxes, then click Add. The address will appear in the
"Static Routing Table." To remove an address, highlight it by clicking on it in the Static Routing Table,
then click Remove.
53 Chapter 4 Using Advanced Setup

UPnP (Universal Plug and Play)

Selecting UPnP in the "Configuring the Advanced Settings" screen generates the "
screen, the Universal Plug and play option is turned on or off by activating the appropriate circle.
Universal Plug and Play is a zero-configuration networking protocol that allows hardware and software
(such as Netmeeting) to operate more efficiently. If Netmeeting is not running properly, activate
, , , v ,
SMTP IMAP IMAP 3
, ,
PROFILE NETBIOS-NS
NAT
, ,
DNS IPSEC IKE IPSEC ESP
, ,
NETBIOS-DGM MICROSOFT-DS
. Disabling allows the computers connected to the
NAT
off unless instructed to do so by the
NAT
, , and ) are
HTTPS NNTP
, ,
SNMP LDAP
" screen. The
NAT
.
ISP
n " screen. In this
UP P
n
UP P
,
NAT
.
19