Existing Installations; Wiring Diagram; Commissioning - ESI ES1247B Installation Instructions Manual

Existing Installations

1. Remove the old programmer from its back plate
mounting, loosening any securing screws as dictated
by its design.
2. Check compatibility of existing back plate & wiring
arrangement with that of the new programmer. See
online Programmer Replacement Guide for direction.
3. Make all necessary changes to back plate & wiring
arrangement to suit new programmer.

Wiring Diagram

Commissioning

Switch on mains supply. Referring to User Instructions (page
3-11):-
1. Use the buttons to ensure correct product functionality.
2. Set timing and programme details in accordance with
customer requirements (page 11).
3. Normally the unit will be left with channel in 'Auto'
mode.
4. Set backlight either permanently ON or OFF in
accordance with customer requirements (page 15).
5. Leave these installation instructions with customer
for reference.
12
1.0-2.5mm
2
6mm MAX
ES1247B
IP30
TM
Max Load: 1380W
6(2) Amp 230 VAC
N L 1
COM OFF
2 3 4
ON
V1.1 2017