Table of Contents
Advertisement
maintenance telephone number in the screen
according to installer set settings.
1: Reminds the user when the annual service is due
by alternating between displaying SER and the
maintenance telephone number in the screen
according to installer set settings and only allows the
system to run in manual operation for
60 minutes.
2: Reminds the user when the annual service is due
by alternating between displaying SER and the
maintenance telephone number in the screen
according to installer set settings and does not allow
the system to run (permanently OFF).
10. Press the Next
nE. Here a new installer code can be entered. Press
+/– to set the first digit, then press the Day button.
Repeat this for all four digits. Press the Next
to confirm the changes and the LCD display will show
SET to confirm.
11. Press the
automatically confirm and return to Run Mode.
Fitting the Back Plate
1. Position the wall-plate (terminals along top edge) with
60mm (min) clearance to its right, 25mm (min) above,
90mm (min) below. Ensure that the supporting surface
will fully cover the back of the programmer.
2. Offer the back plate to the wall in the position where the
programmer is to be mounted, remembering that the
back plate fits to the left side of the programmer. Mark
the fixing positions through the slots in the back plate,
drill and plug wall, then secure back plate in position.
10
button and the LCD display will show
Home button or wait for 15 seconds to
button
Hide quick links:
Advertisement
Table of Contents
