Page 2
Thank you for choosing ESi Controls. All our products are tested in the UK so we are confident this product will reach you in perfect condition and give you many years of service. However, for additional peace of mind, we recommend you register your product online at www.esicontrols.co.uk/warranty for your...
Contents Installation Instructions Technical Data Installation Instructions Installation Safety Instructions Maintenance Safety Notice Technical Settings Setting the Landlord Service Interval Fitting the Back Plate Entering a New Installer Code Existing Installations Wiring Diagram Commissioning...
Technical data Power Supply 230V AC, 50Hz Operating Temperature 0°C to 35°C Swith Rating 230V AC, 6(2) A SPDT Battery Type Lithium Cell CR2032 Enclosure Protection IP30 Plastics Thermolatic, flame retardant Insulation Class Double Wiring For fixed wiring only Back Plate Industry standard Dimensions 140mm(L) x 90mm(H) x 30mm(D)
Installation Safety Instructions The unit must be installed by a suitably qualified person in accordance with the latest IEE Wiring Regulations. Isolate mains supply before commencing installation. Please read all instructions before proceeding. Ensure that the fixed wiring connections to the mains supply is via a fuse rated at not more than 6 amps and class ‘A’...
Safety Notice WARNING! Always isolate the AC mains supply before installing. this product must be fitted by a qualified person, and installation must comply with the guidance provided in the current editions of BS767 (IEE wiring regulations) and part “P” of the building regulations. Technical Settings 1.
Page 9
N.B. Only when the code entered matches either the pre-set or master code can the landlord settings be entered. The factory default code is 0000. 4. The LCD display will show ProG. Press the Next button and the LCD will show En. Press the +/– buttons to turn the landlord functions on/off.
maintenance telephone number in the screen according to installer set settings. 1: Reminds the user when the annual service is due by alternating between displaying SER and the maintenance telephone number in the screen according to installer set settings and only allows the system to run in manual operation for 60 minutes.
3. All necessary electrical connections should now be made. Ensure that the wiring to the wall-plate terminals leads directly away from the terminals and is completely enclosed within the wall-plate aperture. Wire ends must be stripped and screwed to the terminals so that minimal bare wire is showing.
See online Programmer Replacement Guide for direction. 3. Make all necessary changes to back plate & wiring arrangement to suit new programmer. Wiring Diagram ES1247B IP30 1.0-2.5mm Max Load: 1380W 6mm MAX 6(2) Amp 230 VAC V1.1 2017...
Page 14
We are continuously developing our products to bring you the very latest in energy saving technology and simplicity. However, should you have any questions setting up your controls please email us at sales@esicontrols.co.uk or for technical queries call us on our dedicated technical helpline 07539 117468.
Page 15
WARNING: Interference with sealed parts renders the guarantee void. In the interests of continuous product improvement we reserve the right to alter designs, specifications and materials without prior notice and cannot accept liability for errors.