Entering A New Installer Code - ESI ES1247B Installation Instructions Manual

3. All necessary electrical connections should now
be made. Ensure that the wiring to the wall-plate
terminals leads directly away from the terminals and
is completely enclosed within the wall-plate aperture.
Wire ends must be stripped and screwed to the
terminals so that minimal bare wire is showing.
To enter a New Installer Code
1. Move the slider to RUN.
2. Press
enter the landlord settings. A numeric password will be
required to enter these settings.
3. The LCD display will show C0dE. Press the +/– buttons
to enter the first digit of the code. Press the Day button
to move to the next digit. Repeat this until all 4 digits
have been entered and then press the Next
N.B. Only when the code entered matches either the pre-set
or master code can the landlord settings be entered.
The factory default code is 0000.
4. The LCD display will show ProG. Continue to press the
Next
the Day button and the first digit will flash, then use
the +/– buttons to choose a new code using the Day
button to move between digits.
5. When the desired code is entered correctly, press
Next
6. Press
Home, Copy and the + buttons together to
button until the LCD will show NE 0000. Press
button to confirm changes.
Home button to exit the menu.
button.
11