Log Set Placement; Grille Assembly; Logo Installation - Quadra-Fire CB1200-B Owner's Manual

CB 1200 Pellet Stove
F. Optional Log Set Placement Instructions
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
1. Place the front log in first as shown in Figure 20.1. Place
log between firepot and face of appliance with charred
area surrounding firepot.
2. Set the left and right logs onto the front log, placing
the holes in the base of the left and right logs over the
locating pins in front log. See Figure 20.2. Ensure that
the charred ends are facing the firepot.
LOCATING PINS
Figure 20.1
Charred Areas in the Back
Top Log, Left
Figure 20.2
NOTE:
Due to the abrasive nature of a pellet appliance fire, the
logs are not covered under warranty. Any placement varia-
tion other than shown here can cause excessive heat and
shall void the appliance warranty.
Page 20
Top Log
Right
Front Log
G. Optional Gold or Nickel Grille Assembly
Do not open top all the way back so the weight of the
top is supported by the hinges. It will damage the
hinges. It will be necessary to prop the top up with
a supporting brace. You can use the shipping box as
shown in Figure 1.
1. Remove grille from packaging.
2. Lift top up and place shipping box in vertically.
3. Place 1 flap of the box lid into opening for stability.
4. Align the 3 holes in the stove with the holes in the grille.
5. Use a Phillips screwdriver to secure in place.
6. Remove shipping box and lower top.
Align the 3 hoes in the stove
with the holes in the grille and
secure in place.
CAUTION: Do not open top all the way back so the weight is
supported by the hinges. It will damage the hinges. Prop the
top up with supporting brace or use shipping box as shown.
Figure 20.3
H. Installing Logo (Nickel Only)
1. Remove logo from packaging.
2. The logo has 2 studs on the back.
3. Install the logo on the lower left side of the center
panel by pressing the 2 studs into the pre-drilled
holes. See Figure 20.4.
Figure 20.4
7014-082D
CAUTION
Place 1 flap of
box lid into
opening for
stability
Install Logo
September 1, 2008
R