Rear Vent & Rear To Top Vent Adapter .18 D. Brick Set; Brick Clip - Quadra-Fire CB1200-B Owner's Manual

R
D. Optional Brick Set Installation
1. Remove the baffle first, follow instructions on page 33.
2. Slide bottom of left rear brick in first; rotate top edge
toward rear of appliance and then rotate outer edge
toward rear of appliance, until brick slides into place.
Figure 19.1.
3. Repeat with right rear brick.
4. Place left side brick along left side of firebox, making sure
chamfered (beveled) back edge of brick fits snugly next
to rear brick. Figure 19.2.
5. Repeat with right side panel.
6. Complete brick set, correctly installed. Figure 19.3.
Figure 19.1
3
Figure 19.2
3
1
Figure 19.3
September 1, 2008
1
1
2
4
2
E. Brick Clip Installation
Risk of Injury.
• Brick may have small wires protruding from
the back of brick.
1. After the brick set has been installed, 2 brick clips need
to be installed on the outer edge of each baffle to hold
the brick set in place.
2. Remove 2 baffles from the appliance. Slide the baffle up
and the bottom edge should fall down and then lift the
baffle out.
3. Using pliers, bend the brick clip slightly past 90° in the
direction shown in Figure 19.4.
4. Position the brick clip as shown in Figure 19.4 and use
pliers to crimp around the outside edge of the baffle as
shown in Figure 19.5.
Note: Figure 19.5 shows the finished shape of the brick
clip, after being bent around the outside edge of
the baffle.
5. Slide the baffle back into place making sure that the brick
clip holds the side brick toward the wall of the firebox.
Push back on the sides so they will keep the rear bricks
in place. Repeat for opposite side.
Top outside
corner of Baffle
Figure 19.4
Installed Clip
Figure 19.5
7014-082D
CB 1200 Pellet Stove
WARNING
Approximately
1 inch from corner
Outside edge
of Baffle
Use pliers to crimp
Brick Clip around edge
Page 19