Log Set Placement; Grille Assembly; Logo Installation - Quadra-Fire CB1200M-MBK Owner's Manual

R
F. Optional Log Set Placement Instructions
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
1. Place the front log in fi rst as shown in Figure 21.1. Place
log between fi repot and face of appliance with charred
area surrounding fi repot.
2. Set the left and right logs onto the front log, placing
the holes in the base of the left and right logs over the
locating pins in front log. See Figure 21.2. Ensure that
the charred ends are facing the fi repot.
LOCATING PINS
Figure 21.1
Charred Areas in the Back
Top Log, Left
Figure 21.2
NOTE:
Due to the abrasive nature of a pellet appliance fi re, the
logs are not covered under warranty. Any placement varia-
tion other than shown here can cause excessive heat and
shall void the appliance warranty.
November 5, 2014
Top Log
Right
Front Log
G. Optional Gold or Nickel Grille Assembly
Do not open top all the way back so the weight of the
top is supported by the hinges. It will damage the
hinges. It will be necessary to prop the top up with
a supporting brace. You can use the shipping box as
shown in Figure 1.
1. Remove grille from packaging.
2. Lift top up and place shipping box in vertically.
3. Place 1 fl ap of the box lid into opening for stability.
4. Align the 3 holes in the stove with the holes in the grille.
5. Use a Phillips screwdriver to secure in place.
6. Remove shipping box and lower top.
Align the 3 hoes in the stove
with the holes in the grille and
secure in place.
CAUTION: Do not open top all the way back so the weight is
supported by the hinges. It will damage the hinges. Prop the
top up with supporting brace or use shipping box as shown.
Figure 21.3
H. Installing Logo
1. Remove logo from packaging.
2. The logo has 2 studs on the back.
3. Install the logo on the lower left side of the center
panel by pressing the 2 studs into the pre-drilled
holes. See Figure 21.4.
Figure 21.4
7014-179H
CB 1200 Pellet Stove
CAUTION
Place 1 flap of
box lid into
opening for
stability
Install Logo
Page 21