F. Panel & Trim - Quadra-Fire PELLET INSERT CB1200I Owner's Manual

R
R R
F. Panel and Trim Set (Cont'd)
5. Hold side curtains in open position and lower panel set
over insert setting lower edge of top panel in slot between
hopper lid and panel support as shown in Figure 23.1.
Place existing screw head (installed in Figure 23.2) into
locator hole in floor of insert. Figure 23.2.
6. Lift hopper lid and press down on panel top while installing
(4) 8-32 x 3/8 inch screws into holes in panel support. (If
screws have been factory installed, tighten to secure panel
to panel support.) Return hopper lid to closed position.
7. Install a corner bracket on each side trim piece. Slide
brackets into top trim from each side and secure with
flathead screwdriver. Attach trim assembly to panel set
as follows:
a. Ensure that brackets face towards the back.
b. Align trim assembly to panel set sides and slide down.
Figure 23.1
Panel Locator Hole
Figure 23.2
February 3, 2010
Figure 23.3
View of "L" Bracket
Figure 23.4
Figure 23.5- Completed View
7014-188B
CB1200-I Pellet Insert
installed
Page 23