Clearances To Combustibles, Masonry & Zero Clearance; Minimum Opening For Factory Built Fireplace; Masonry Minimum Opening; Floor Protection - Quadra-Fire PELLET INSERT CB1200I Owner's Manual

CB1200-I Pellet Insert
C. Minimum Clearances To Combustibles for
Masonry and Zero Clearance Fireplaces
A
E
Figure 10.1
A Louvers to combustible
side wall
Insert top to mantel
B
C Top to Face Trim
D Hearth Extension - Front
E Hearth Extension - Sides
D. Minimum Opening for Masonry and Zero
Clearance Fireplaces for Built-In Using
Rear Shroud
B
Figure 10.2
A Rear Width
Depth
B
Height - Top Vent
C
*
Height - Rear Vent
Front Width
D
The size of your floor protector choice must be added to
*
this dimension. If using Quadra-Fire floor protector, Part
811-0730, allow 1-1/2 inches (38mm).
Page 10
MANTEL
Face Trim
B
C
D
Inches Millimeters
153
6
12 305
3
76
153
6
203
8
C
A
D
Inches Millimeters
22
558
15-1/2 393
25-1/2
647
22-1/2
571
29-1/4 743
E. Masonry Minimum Opening
B
Location
A Rear Width
Depth
B
C Height - Top Vent
Front Width
D
F. Floor Protection
1. Zero Clearance Installations*
It is necessary to install a floor protection of non-combus-
tible material with a R value of 3.0 (1 inch [25mm] minimum
thickness with a "k" value of 0.58) or a 1 inch (25mm) air
space between insert base and hearth.
2. Non-Zero Clearance Installations*
A non-combustible floor protector is required with a mini-
mum R value of 3.0 (1 inch [25mm] minimum thickness with
a "k" value of 0.58) extending 6 inches (153mm) in front of
the insert and 8 inches (203mm) to each side of the door
opening.
* See alternate floor protection worksheet.
NOTE: A Quadra-Fire floor protector (Part 811-0730) is
available through your dealer to be used as a floor protec-
tor for the section under the insert body only. Floor protec-
tion to front and sides of insert unit must be supplied in
addition to this part.
7014-188B
C
A
D
Inches Millimeters
22
558
13 330
19-1/2
495
29-1/4 743
February 3, 2010
R