Polaris RZR 170 2009 Service Manual page 164

CVT / TRANSMISSION
5. Assemble output shaft housing to case with existing shims.
If components were replaced you must inspect output gear
pinion depth. See "Output Gear Pinion Depth Adjustment"
on page 7.19.
Output Housing:
14 ft. lbs. (19 Nm)
6. Install outer cover (oil fill cover).
7. Add 27 fl. oz. (800ml) of oil.
L
UBRICANT
AGL - Synthetic ATV
Gearcase Lubricant
8. Verify vent hose is clear. After installing engine in frame,
route and secure hose lightly as shown with open end (G)
pointing down.
7.18
= T
C
APACITY
27 fl. oz. (800 ml)
G
9. After installation in the frame, adjust shift cables in the
following manner:
• Place gear selector in NEUTRAL
• Verify transmission shift arm is in NEUTRAL
Shift Arm - Neutral Position
• Attach cables to bracket and to shift arm.
• Adjust each cable until slack is removed from each
cable and tighten cable adjusters securely.
• Check for proper shift operation