Electrical And Ignition System; Battery Maintenance - Polaris RZR 170 2009 Service Manual

3. Pull down on the chain tensioner to move it out of the way,
then measure chain deflection. It should have 1/4"-1/2" (6-
12 mm) deflection.
4. Loosen the four rear housing mount bolts (two on each end
of axle).
5. Loosen the chain adjuster locknuts.
6. Turn the chain adjusters evenly to achieve 1/4"-1/2" (6-12
mm) chain deflection.
7. Torque the chain adjuster locknuts. Hold the adjuster stud
securely while tightening the nut to avoid breaking the stud.
Chain Adjuster Locknuts: 18 ft. lbs. (25 Nm)
8. Torque the four rear housing mount bolts.
Rear Housing Mounting Bolts: 43 ft. lbs. (60 Nm)
= T
= T

ELECTRICAL AND IGNITION SYSTEM

Battery Maintenance

Keep battery terminals and connections free of corrosion. If
cleaning is necessary, remove the corrosion with a stiff wire
brush. Wash with a solution of one tablespoon baking soda and
one cup water. Rinse well with tap water and dry off with clean
shop towels. Coat the terminals with dielectric grease or
petroleum jelly.
WARNING
Battery electrolyte is poisonous. It contains
sulfuric acid. Serious burns can result from
contact with skin, eyes or clothing. Antidote:
External: Flush with water.
Internal: Drink large quantities of water or milk.
Follow with milk of magnesia, beaten egg, or
vegetable oil. Call physician immediately.
Eyes: Flush with water for 15 minutes and get
prompt medical attention.
Batteries produce explosive gases.
Keep sparks, flame, cigarettes, etc. away.
Ventilate when charging or using in an enclosed
space. Always shield eyes when
working near batteries.
KEEP OUT OF REACH OF CHILDREN.
NOTE: Batteries must be fully charged before use or
battery life will be reduced by 10-30% of full
potential. Charge battery for 3-5 hours at a current
equivalent to 1/10 of the battery's rated amp/hour
capacity. Do not use the vehicle's stator/alternator
to charge a new battery.
MAINTENANCE
2.27
2