Magnetic Stylus - Omega DPG409 SERIES User Manual

5
Display Features & Meter Operation

Magnetic Stylus

A magnetic stylus is attached to your meter. This stylus is used to activate the
front buttons on the display. If you do not need to view the "MIN", "MAX"
or "AVERAGE" readings during normal operation, or have a need to turn the
backlight on during normal operation you can remove and store this stylus. You
will need to select "Disable Keypad" during the setup and configuration process.
Button Operation
The "MODE" and "SET" buttons located of the front display of your meter are
activated by waving or taping the magnetic stylus included with your unit above
or onto the keypad button symbol on the front meter label.
Mode Button Operation – To activate the "MODE" button, place the tip of the
magnetic stylus over the "MODE" button and hold for three seconds until the
unit enters the "MODE" menu. Then move away the magnetic stylus. Each time
the magnetic stylus is again placed near the "MODE" button the meter will step
through each parameter.
"SET" Button Operation - The "SET" button has two primary functions.
Independently the button is used to turn the backlighting on. To activate the
backlight, place the tip of the magnetic stylus over the "SET" button and hold for
three seconds until the backlighting turns on. The backlighting will remain on
for the amount of time you selected during the setup and configuration process.
Note: if you selected "Always Off" when setting the meter up, then the "SET"
button will not turn the backlighting on from the front keypad.
When in the "MODE" menu, the "SET" button is used for the following:
5-2
MAGNETIC TIP
1. To reset the MIN or MAX values to the current pressure reading. (The
AVG value is the average of the MIN and MAX values.)
2. To silence the High or Low alarm, when in the "HAL" or "LAL"
screen and the alarm is configured for "Latching". This will cause
the display to stop blinking, however, the alarm output will remain
activated until the alarm condition clears.
3. To turn the wireless transmitter "On" or "Off" while in the "WRLS"
screen.
4. To select units of measure while in the "UNIT" screen.
See appendix A: Units Conversion Table, for display
limitations when displaying in units other than the gauges
native units.
Figure 5-3. Magnetic Stylus
NOTE: