Cisco 7931G Manual page 22

UCR 2008
Related Topics
Security Configuration Menu
802.1X Authentication and Status
UCR 2008
The IP Phones using SCCP support Unified Capabilities Requirements (UCR) 2008 by providing the following
functions:
• Support for Federal Information Processing Standard (FIPS) 104-2: To support FIPS 104-2, the phone
• TVS IPv6: The phone displays the IPv6 address of a Trust Verification Service (TVS) server, if an IPv6
• 80-bit SRTCP Tagging: The phone handles both 32-bit and 80-bit SRTCP packet headers seamlessly.
As an IP Phone administrator, some of these functions require you to set up specific parameters in the Cisco
Unified Communications Manager administration interface.
The following table shows where you can find addition information about UCR 2008 in this and other
documents.
Table 6: Cisco Unified IP Phone UCR 2008 Topics
Topic
Detailed explanation of security, including set up,
configuration, and troubleshooting information for Cisco
Unified Communications Manager and Cisco Unified IP
Phones
Setting up UCR 2008 parameters
Troubleshooting POST problems
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 9.0 (SCCP
and SIP)
22
requires:
◦ Use of Power On Self Testing (POST) to ensure that the appropriate encryption algorithms are
available. If the phone does not have the correct modules in the firmware, the phone will fail to
boot.
◦ Use of HTTPS for all internet communications.
◦ Disabling of Web Access to the phone.
◦ That the Cisco Unified Communications Manager to be set up for FIPS compliance (for example,
disabling 802.1x EAP-MD5).
address is available.
Reference
See Troubleshooting Guide for Cisco Unified Communications
Manager.
UCR 2008 Setup
Cisco Unified IP Phone Displays Security Error Message
Cisco Unified IP Phone 7931G