Cable Fabrication - Furuno FCV-288 Operator's Manual

4. INSTALLATION
4.6

Cable Fabrication

Power cable
Connect the power cable to the power connector. Connect the leads to the battery (12 or 24 VDC);
white to plus(+) terminal and black to minus(-) terminal. Connect the shield to ship's ground.
Note: The fuse is not waterproof. Wrap the fuse holder with vinyl tape to keep water out of the
fuse holder.
Transducer cable
Separate the transducer cable well away from power cables to prevent interference. Connect the
cable to the transducer port (for high frequency and/or low frequency) at the rear of the display
unit. Fabricate the cable as below.
[Composite transducer]
Cable connector
Power cable
Black
Fuse (3A)
BATTERY
Approx. 300
Sheath
Shield
Extract cores from here and cut inner materials.
Approx. 100
Shield
Vinyl tape
30
8 - 9
Attach WAGO
Wrap shield around sheath 30 mm and cut
connector.
excess shield. Bind this part to the plate.
(See next page.)
BLK, RED: L side
BLU, GRN: H side
Lead wire
White
Fuse (3A)
Vinyl tape
Note: Never connect the shield to #2 of
the WAGO connector.
30