Multi-Zone - Integra DRX-R1.1 Basic Manual

> Before Start > Part Names

Multi-zone

1
Basic Operations
You can enjoy audio in the separate room
by, for example, playing a Blu-ray Disc
player in the main room (where this unit is
located) and listening to internet radio in
the separate room (ZONE 2/ZONE 3).
0 DSD and Dolby TrueHD audio signals
are not output to ZONE 2/ZONE 3 when
selected with the "NET" input selector.
0 You cannot select different stations for
the main room and separate room with
the AM/FM radio. When you select the
station for the separate room, the main
room also switches.
0 Power consumption in standby mode
increases when the multi-zone function
is being used.
Perform the following procedure when the
unit is on.
1. To switch to the remote controller mode
for controlling ZONE 2, while holding
down Mode (f) on the remote controller,
press Zone 2 (d) for 3 or more seconds
32
> Install > Initial Setup
2
until the remote indicator blinks twice.
To switch to the remote controller mode
for controlling ZONE 3, while holding
down Mode (f) on the remote controller,
press Zone 3 (e) for 3 or more seconds
until the remote indicator blinks three
times.
2. Point the remote controller at the main
unit and press Í (a).
"Z2" or "Z3" lights on the main unit
display.
3. Press the input selector button (b) of the
input to be played in the separate room.
0 On the main unit, after pressing Zone
2 or Zone 3, within 8 seconds press
the input selector button to select the
input to be played in the separate
room. To play the same source in the
main room and separate room, press
Zone 2 or Zone 3 on the main unit
> Playback
3
twice.
4. To adjust the volume on the power
amplifier in the separate room or the
ZONE SPEAKER, adjust with volume
buttons on the remote controller. To
control on the main unit, press Zone 2 or
Zone 3 and adjust with the Master
Volume dial within 8 seconds.
0 Adjust the volume on the pre-main
amplifier if you have connected with a
pre-main amplifier in the other room.
0 You can also adjust the sound quality
of a power amplifier connected in a
separate room. After pressing Zone 2
or Zone 3 on the main unit, within
8 seconds press Tone and press the
i or j button to adjust.
0 The information for a connected
device can be displayed on the TV
screen in a separate room. Press the
button while the remote controller
is in the mode for controlling ZONE 2.
> Advanced Manual
Troubleshooting | Supplementary Information, etc.
a
b
c
d
e
f