Integra DRX-R1.1 Basic Manual page 61

> Specifications > Advanced Setup
■ 3. Power Management
Setting Item Default Value
Sleep Timer Off
Auto Standby On/Off
Auto Standby in Off
HDMI Standby
Through
> Listening Modes > Network Functions
Setting Details
Allows the unit to enter standby automatically when
the specified time elapses. Select a value from "30
minutes", "60 minutes", and "90 minutes".
"Off": Does not turn the unit to standby
automatically.
This setting places the unit on standby
automatically after 20 minutes of inactivity without
any video or audio input. (When "Network Standby"
is on, this becomes the Hybrid Standby mode
which reduces the increase in power consumption
to a minimum.)
"On": The unit will automatically enter standby
mode ("AUTO STBY" will light.)
"Off": The unit will not automatically enter standby
mode.
• "Auto Standby" is displayed on the display and
TV screen 30 seconds before the Auto Standby
comes on.
• "Auto Standby" does not work when Zone 2/
Zone 3 is active.
• Default values vary depending on the regions.
Enable or disable "Auto Standby" while "HDMI
Standby Through" is on.
"On": The setting will be enabled.
"Off": The setting will be disabled.
• This setting cannot be set to "On" if "Auto
Standby" and "HDMI Standby Through" are set
to "Off".
Setting Item Default Value
Network Standby On
• Wait for a while if "Network Standby" cannot be selected. It will appear when the network feature is
started.
■ 4. 12V Trigger A
Set when outputting the control signal (maximum 12 V/100 mA) through the 12V TRIGGER
OUT A jack. Different settings can be set for each input selector. You can enable power link
operation when you connect the unit and the external devices equipped with 12V trigger
input jack.
Setting Item Default Value
Delay 0 sec
> Basic Manual
Troubleshooting | Supplementary Information, etc.
Setting Details
When this feature is turned "On", you can turn
on the power of the unit via the network using
an application such as Integra Remote that can
control this unit.
• When "Network Standby" is used, the power
consumption increases even when the unit
is on standby. However, the increase in
power consumption is kept to a minimum by
automatically entering the Hybrid Standby
mode, where only the essential circuit is
operating.
• When the connection to the network is lost,
"Network Standby" is disabled to reduce power
consumption. Use the power button on the
remote controller or main unit to turn the unit on
if this happens.
Setting Details
Set after how many seconds the 12V trigger output
will occur in response to the unit's operation. As
some devices cause a large current when they turn
on, delay the output if such devices are connected.
Select a value between "0 sec" to "3 sec".
25