Integra DRX-R1.1 Basic Manual page 51

> Specifications > Advanced Setup
Setting Item Default Value
Surr Back Left 7' 0" / 2.10 m
Surround Left 7' 0" / 2.10 m
Subwoofer 1 12' 0" / 3.60 m
Subwoofer 2 12' 0" / 3.60 m
• Default values vary depending on the regions.
• Distance units can be switched by pressing Mode on the remote controller. When the unit is set as
feet, you can set between 0' 0" 1/2 and 30' 0" in increments of 1/2. When the unit is set as meters,
you can set between 0.01 m and 9.00 m in increments of 0.01 m.
> Listening Modes > Network Functions
Setting Details
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
■ 4. Level Calibration
Setting Item Default Value
Front Left 0.0 dB
Center 0.0 dB
Front Right 0.0 dB
Height 1 Left 0.0 dB
Height 1 Right 0.0 dB
Height 2 Left 0.0 dB
Height 2 Right 0.0 dB
Surround Right 0.0 dB
> Basic Manual
Troubleshooting | Supplementary Information, etc.
Setting Details
Select a value between "−12.0 dB" and "＋12.0
dB" (in 0.5 dB increments). A test tone will be
output each time you change the value. Select the
desired level.
Select a value between "−12.0 dB" and "＋12.0
dB" (in 0.5 dB increments). A test tone will be
output each time you change the value. Select the
desired level.
Select a value between "−12.0 dB" and "＋12.0
dB" (in 0.5 dB increments). A test tone will be
output each time you change the value. Select the
desired level.
Select a value between "−12.0 dB" and "＋12.0
dB" (in 0.5 dB increments). A test tone will be
output each time you change the value. Select the
desired level.
Select a value between "−12.0 dB" and "＋12.0
dB" (in 0.5 dB increments). A test tone will be
output each time you change the value. Select the
desired level.
Select a value between "−12.0 dB" and "＋12.0
dB" (in 0.5 dB increments). A test tone will be
output each time you change the value. Select the
desired level.
Select a value between "−12.0 dB" and "＋12.0
dB" (in 0.5 dB increments). A test tone will be
output each time you change the value. Select the
desired level.
Select a value between "−12.0 dB" and "＋12.0
dB" (in 0.5 dB increments). A test tone will be
output each time you change the value. Select the
desired level.
15