Mitsubishi Electric MSC-07RV Service Manual page 159

OPERATING PROCEDURE
2. Removing the relay panel.
(1) Remove the cabinet. (Refer to 1)
(2) Disconnect the following connectors.
. Compressor (MC1,MC2)
. Outdoor fan motor
. Solenoid coil (21R1,21R2,21R3,21R4,21RA,21RB)
3. Removing the propeller.
(1) Remove the cabinet.
(2) Remove the propeller nut.
(3) Remove the propeller.
Note
: Loosen the propeller in the rotating direction for removal.
When setting the propeller, align the motor-shaft cut
section.
4. Removing the outdoor fan motor.
(1) Remove the cabinet. (Refer to 1)
(2) Remove the propeller. (Refer to 3)
(3) Disconnect the connector remove the clamp of outdoor fan
motor lead wire.
(4) Remove the screws fixing the outdoor fan motor.
Photo 4 Solenoid coil connector
(21RA,21RB)
Compressor connector
(MC1,MC2)
Photo 5
Propeller
Photo 6
Clamp
Outdoor
fan
motor
159
PHOTOS
Solenoid coil connector
(21R1,21R2,21R3,21R4)
Screws
Propeller nut
Outdoor fan motor
set screws