Mitsubishi Electric MSC-07RV Service Manual page 157

OPERATING PROCEDURE
4. Removing the compressor.
(1) Remove the cabinet.(Refer to 1.)
(2) Remove the terminal cover.
(3) Pull out lead from the compressor terminal,then remove
the terminal overcurrent relay.
(4) Remove the suction pipe welded section and discharge
pipe welded section using a burner.
Pull out when the welding melts.
(5) Remove the sound proof felt.
(6) Remove the compressor 3 set nuts.
(7) Remove the compressor.
NOTE:
Before using the welder, confirm that the pressure gauge is
0 Kg/cm 2 .
When using the welder, leave the service port open and
release the pressure to avoid expansion by heat.
5. Removing the compressor.
(1) Remove the cabinet.(Refer to 1.)
(2) Remove the terminal cover.
(3) Pull out lead from the compressor terminal,then remove
the terminal overcurrent relay.
(4) Remove the screws fixing the back panel.
(5) Remove the suction pipe welded section and discharge
pipe welded section using a burner.
Pull out when the welding melts.
(6) Remove the sound proof felt.
(7) Remove the compressor 3 set nuts.
(8) Remove the compressor.
Photo 4
Discharge pipe
157
PHOTOS
Suction pipe
Sound proof felt