Disassembly Instructions - Mitsubishi Electric MSC-07RV Service Manual

14

DISASSEMBLY INSTRUCTIONS

<"Terminal with lock mechanism" Detaching points>
In case of terminal with lock mechanism detach the terminal as shown below.
(1)
14-1. MSC-07RV -
INDOOR UNIT
OPERATING PROCEDURE
1. Removing the front panel
(1) Remove the screws caps of the front panel.
Remove the screws.
(2) Pull the panel down to your side slightly and unhook the
catches at the top.
2. Removing the electronic control P.C. board and the
display P.C. board.
(1) Remove the front panel. (Refer to 1)
(2) Remove the screw of the electrical cover.
Remove the electrical cover.
(3) Remove the V.A. clamp.
Remove the screw of the terminal block.
(4) Remove the cord clamp.
(5) Remove the screw of the ground wire.
(6) Disconnect all the connectors and all the lead wires on the
electronic control P.C. board.
(7) Remove the electronic control P.C. board and the display
P.C. board.
1Slide the sleeve.
2Pull the terminal while
pushing the locking
lever.
MSC-09RV -
E1 E1
(2)
MSC-12RV -
E1
Photo 1
Photo 2
148
1Hold the sleeve, and
pull out the terminal
slowly.
PHOTOS
Front panel
Screws
Ground
Fan motor connector
V.A.clamp
Room temperature
thermistor connector
Indoor electronic
control P.C.board
Vane motor
connector
Cord clamp
Terminal block
cover screw