Table of Contents
Advertisement
6866588D06–RB
Chapter 5: Features
NOTICE: The browser does not open if you are in a call, in Emergency Mode, in Call Out, in
message editor, in PIN lock state, or when switching to DMO.
5.13.16.2
Viewing WAP Messages
Procedure:
1 From the home screen, press the Menu key.
2 Select Messages → WAP Box.
3 Select the required message.
4 Select Go to to view the message in the browser.
5.14
Call-Out
NOTICE: This feature is a paid feature.
This feature allows you to receive Call-Out alerts. On receiving the Call-Out messages, the radio
interrupts current services and attends to the Call-Out alert without any further delay. After the Call-Out
is cleared by the dispatcher, the radio exits Call-Out mode and reverts to normal mode.
During Call-Out mode, you are only able to receive Emergency calls. However, if your service provider
configures Emergency Calls to be ignored during Call-Out mode, the radio rejects them with no
notification.
If your service provider temporarily blocked the use of PTT in the Call-Out, pressing PTT in the Call-
Out mode is considered an invalid key press until the timer expires.
The time-stamp on the Call-Out alert indicates the time and date when the Call-Out is received.
To read an entire Call-Out message, scroll down the screen by pressing the Down Navigation key. The
length of the message is indicated by the vertical bar on the left of the screen.
Figure 6: Call-Out Message
5.14.1
Types of Call-Out Alerts
There are four types of the Call-Out alerts:
Normal Call-Out
An alert message that is sent by a dispatcher either to a single radio or to a group of radios.
There two types of Normal Call-Out:
With user receipt
The radio gets to the Accepted phase when you:
•
select Accept, Reject, Standby.
•
the acknowledgment timer runs out.
114
Send Feedback
Advertisement
Table of Contents
