Using The Motion-Control Levers; Driving The Machine - Toro TimeCutter SS 5000 Operator's Manual

Using the Motion-Control
Levers
Figure 20
1. Motion-control
lever—P position
ARK
2. Center, unlocked position
3. Forward

Driving the Machine

The drive wheels turn independently, powered by hydraulic
motors on each axle. You can turn 1 side in reverse while you
turn the other forward, causing the machine to spin rather
than turn. This greatly improves the machine maneuverability
but may require sometime for you to adapt to how it moves.
The throttle control regulates the engine speed as measured
in rpm (revolutions per minute). Place the throttle control in
the F position for best performance. Always operate in
AST
the full throttle position when mowing.
WARNING
The machine can spin very rapidly. You may lose
control of the machine and cause personal injury or
damage to the machine.
• Use caution when making turns.
• Slow the machine down before making sharp
turns.
g004532
4. Backward
5. Front of machine
Driving Forward
Note: Always use caution when backing up and turning.
1. Move the levers to the center, unlocked position.
2. To go forward, slowly push the motion-control levers
forward (Figure
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion-control levers
rearward (Figure
20
21).
G008952
Figure 21
22).
G008953
Figure 22
g008952
g008953