Drive System Maintenance; Checking The Tire Pressure - Toro TimeCutter SS 5000 Operator's Manual

Note: Retain all fasteners.
2. Lift the control pane up to access the main wire harness
and fuse block (Figure
3. To replace a fuse, pull out on the fuse to remove it
(Figure 45).
2
Figure 45
1. Main (30 A)
4. Return the control panel to its original position.
Note: Use the screws removed previously to secure
the panel to the machine.
45).
1
G014921
2. Charge circuit (25 A)
Drive System
Maintenance

Checking the Tire Pressure

Service Interval: Every 25 hours—Check tire pressure.
Maintain the air pressure in the front and rear tires as
specified. Uneven tire pressure can cause uneven cut. Check
the pressure at the valve stem
when they are cold to get the most accurate pressure reading.
Refer to the maximum pressure suggested by the tire
manufacturer on the sidewall of the caster wheel tires.
Inflate the rear drive wheel tires to 90 kPa (13 psi).
g014921
1. Valve stem
37
(Figure 46). Check the tires
Figure 46
g000554