Stopping The Machine - Toro TimeCutter SS 5000 Operator's Manual

Using the Smart Speed
System
TM
The Smart Speed Control-System lever, located below the
operating position (Figure
to drive the machine at 3 ground speed ranges—trim, tow,
and mow.
Figure 23
1. Smart-speed lever
To change speeds, do the following:
1. Move the motion-control levers to neutral and outward
to the P position.
ARK
2. Disengage the blade-control switch.
3. Adjust the lever to the desired position.
The following are only recommendations for use.
Adjustments vary by grass type, moisture content, and the
height of the grass.
Suggested Trim
uses:
Parking X
Heavy, wet X
grass
Training X
Bagging
Mulching
Normal
mowing
Transport
Trim
This is the lowest speed. The suggested uses for this speed
are as follows:
•
Parking
•
Heavy, wet grass mowing conditions
•
Training
TM Control
23), gives the operator a choice
Tow Mow
X
X
X
X
Tow
This is the medium speed. The suggested uses for this speed
are as follows:
•
Bagging
•
Mulching
Mow
This is the fastest speed. The suggested uses for this speed
are as follows:
•
Normal mowing
•
Transporting the machine

Stopping the Machine

To stop the machine, move the motion-control levers to
N and outward to the P
EUTRAL
g027625
blade-control switch, ensure that the throttle is in the F
position, and turn the ignition key to O
from the ignition switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion-control levers outward to the P
when leaving the machine unattended, even if just
for a few minutes.
21
position, disengage the
ARK
AST
. Remove the key
FF
position
ARK