Interface Related Features
RS-232 Interface Features — cont.
ACK Character
START
MODE
Sets the ACK character from the set of ASCII charac-
ters or any decimal value from 000 to 255. Pad
entries of less than three digits with zeros, as in
"005". To configure this feature, scan the "START" bar
code above to place the unit in Programming Mode,
then the "Set ACK Character," followed by the digits
from the Alphanumeric table in
Numeric Pad
Exit programming mode by scanning the "END" bar-
code below.
Set ACK
Character
END
3-24
BARCODE
representing your desired character.
DEFAULT SETTING FOR THIS FEATURE: 006
PowerScan
Appendix C, Alpha-
®
7000 Linear Imager