Table of Contents
Advertisement
Interface Related Features
Keyboard Wedge/USB Keyboard — cont.
Intercharacter Delay
NOTE
START
MODE
One-half of the delay specified below is inserted
between scancodes within each character. If the trans-
mission speed is too high, the system may not be able
to receive all characters. You may need to adjust the
delay to make the system work properly. Selectable
from 00 to 255 in 10msec increments. Use hexidecimal
(range: 00 to FF hexidecimal) to set the delay.
To configure this feature, scan the "START" bar code
above to place the unit in Programming Mode, then the
"Set Intercharacter Delay," followed by the digits from
the Alphanumeric table in
Numeric Pad
programming mode by scanning the "END" barcode
below
Set
Intercharacter
Delay
END
3-48
This feature does not apply to the USB Keyboard
interface.
BARCODE
representing your desired length. Exit
DEFAULT SETTING FOR THIS FEATURE:
00 (No Delay)
PowerScan
Appendix C, Alpha-
®
7000 Linear Imager
Advertisement
Table of Contents
