Yamaha NUAGE MASTER Ncs500-CT Operation Manual page 49

Button Functions
CONTROL ROOM Section
[Display access] These controllers are used to
operate the DAW A Nuendo.
[REF]
[SOLO CLEAR]
[MUTE]
[DIM]
[DOWNMIX 1] –
[DOWNMIX 4]
[MONITOR A] –
[MONITOR D]
[PHONES]
[CONTROL ROOM LEVEL
knob]
[CONTROL ROOM
display]
MONITOR SOURCE Section
[Display access] These controllers are used to
operate the DAW A Nuendo.
[EXT]
[MIX]
[SUM]
[CUE 1] – [CUE 4]
[EXT 1] – [EXT 6]
[E7]/[E8] These buttons are not used.
[MIX 1] – [MIX 8] These controllers are used to
operate the DAW A Nuendo.
CUES Section
[Display access] These controllers are used to
operate the DAW A Nuendo.
[MUTE 1] – [MUTE 4]
[SIG indicator]
COMMUNICATION Section
[Display access] These controllers are used to
operate the DAW A Nuendo.
[C1]/[C2]
[TALK BACK]
TRANSPORT Section
[Display access]
*1
[PRE ROLL]
[POST ROLL]
[PUNCH IN]
[PUNCH OUT]
[CYCLE]
[SYNC ONLINE]
*1
[LEFT]
[RIGHT]
[PREV EVENT]
[NEXT EVENT]
*1
[MEM]
[ZAP]
[] (fast rewind)
*1
[] (fast forward)
[] (stop)
[] (play)
*1
[] (record)
Appendix
This button is used to open and
close the Transport window. Its
indicator lights up while the
Transport window is open.
This button is used to turn on and
off pre-roll.
This button is used to turn on and
off post-roll.
This button is used to turn quick
punch on and off (same as the
Quick Punch command in the
Options menu). Its indicator lights
up when quick punch is on.
Same as above.
This button is used to turn loop
playback on and off (same as the
Loop Playback command in the
Options menu). Its indicator lights
up when loop playback is on.
This button is used to take Pro Tools
online and offline (same as the
Online command in the Options
menu). When taken online, the
button's indicator will flash until a
synchronization signal is received.
Once a signal has been received, it
will stay lit.
This button is used to set in points
during playback.
This button is used to set out points
during playback.
Not applicable.
This button rewinds from the current
cursor position (it's non-latching).
This button fast forwards from the
current cursor position (it's non-
latching).
This button stops playback and
recording.
This button starts playback from the
current cursor position.
This button arms Pro Tools for
recording ([REC] button indicator
flashing), recording is started by
pressing the [PLAY] button ([REC]
button indicator lit continuously).
NUAGE MASTER Operation Manual 49