If An Id Sequence Is Invalid - Fluke DSX-600 Technical Reference Handbook

To make an ID set
When you make an ID set, the tester saves it in the
project shown on the home screen.
1 On the home screen, tap the PROJECT panel.
2 On the PROJECT screen, tap NEW ID SET.
3 On the CABLE ID SETUP screen, tap the First ID panel, then
use the keyboard to enter the first ID for the set.
4 Tap the Last ID panel, use the keyboard to enter the last ID for
the set, then tap DONE.
If you do not enter a Last ID, the tester uses the
first ID as the Next ID and increments that ID each
time you save a result. See "About Next ID Sets"
on page 168.
5 To see the ID set, tap REVIEW.
6 On the CABLE ID REVIEW screen or the CABLE ID SETUP
screen, tap Save.

If an ID Sequence is Invalid

If an ID sequence is invalid, use these rules for valid sequences to
find the problem:
The First and Last IDs must have the same numbers of

characters. For example you cannot use 1 as the First ID and
999 as the Last ID. A valid sequence is 001 to 999.
 An ID set cannot contain an ID used in another set.
 The types of characters in each position must agree between
the First and Last IDs. For example:
 You cannot use the letter "O" in the First ID and the
number "0" in the same position in the Last ID.
Note
Note
Chapter 8: Use Projects
How to Make ID Sets
167