Philips Lifeline Instructions For Use Manual page 68

Medical alert service; includes: gosafe mobile system and homesafe system
Hide thumbs Also See for Lifeline:
Table of Contents

Advertisement

• CFR47 FCC Part 15 Subpart C, Section 15.249:2012 (7000AHB & 7000PHB)
• CFR47 FCC Part 15 Subpart C, Section 15.249, October 1, 2011 (7000C, 7000MHB, 7100MHB)
• CFR47 FCC Part 68 (7000L)
UL1635, UL1637 and CSA 22 .2 No. 205 Compliance
The maximum separation (range) of the equipment, under open field test conditions and for
comparative purposes only, is 600 feet. This range may be significantly reduced when the equipment is
installed in a typical home. The 700MHB and 7100MHB comply to UL1635 and UL 1637 when
GoSafe are within the range of communicators.
For compliance to UL 1637 for U.S. installations only:
A clear, plastic power supply retaining strip is provided in the packaging with this system. Its purpose is
to prevent the home communicator power supply from accidentally pulling out of the AC wall outlet
under force. To use:
1. Plug the home communicator power supply into the outlet you select to power your system,
following the instructions and precautions herein.
2. Clean the wall area roughly 3" on either side of the wall outlet cover with a paper towel or cloth
and a general purpose household cleaner such as glass cleaner. Do not use furniture polish or
oil-based cleaners for this step as this cleaning is to ensure that the adhesion area is devoid of any
dirt, oil or grease that would otherwise prevent the adhesive from sticking properly.
3. Spray the cleaner on the cloth and gently wipe the target area on either side of the outlet cover as
described in step 2. Do not spray the cleaner on the wall.
4. Ensure the area you have cleaned is dry prior to proceeding to the step 5.
5. Peel the release liner from the adhesive panels on the strip and affix it across the back of the
power supply, adhering the 2 adhesive panels to the wall on each side of the power supply.
Environmental
Temperature
Relative
Humidity
Atmospheric Pressure
Altitude
*
*applies to AHB and MHB only
Operating
41° F to 95° F
(5° C to 35° C)
10 to 90% (non-condensing)
101 kPa to 77 kPa (approximately
0-7500 ft/0-2286 m)
6,600 feet (2 km) Maximum
Storage
-4° F to 140° F
(-20° C to 60° C)
10 to 90% (non-condensing)
N/A
N/A
61

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

GosafeHomesafe

Table of Contents