Philips Lifeline Instructions For Use Manual page 51

DEPLETED BATTERY End Device (7000MHB/7100MHB)
Alarm Event
Description
Priority
Device Action
Alarm Event Reported/
Displayed Locally?
Alarm Event Reported
to Lifeline?
Device Hardware Failure (7000PHB / 7000AHB / 7000MHB /7100MHB/ 7000C / 7000L)
Alarm Event
Description
Priority
Device Action
Alarm Event Reported/
Displayed Locally?
Alarm Event Reported
to Lifeline?
Software Failure End Device (7000PHB / 7000AHB / 7000MHB/7100MHB)
Alarm Event
Description
Priority
Device Action
Alarm Event Reported/
Displayed Locally?
Alarm Event Reported
to Lifeline?
56
When the charge level of the Mobile Help Button rechargeable battery
is critically low (below 3.7V), a Warning Message is displayed.
Medium
Operates normally until the battery is fully depleted.
Yes. Mobile Help Button LED flashes orange, plays single sound/tone,
and a Voice Message. Message Button on the Home Communicator
flashes, when the End Device is within range. Voice Message plays
upon pressing the Message Button. This alarm will self cancel once the
battery charge reaches an acceptable level.
Yes. A silent Maintenance Signal is sent to the Call Center by the End
Device from anywhere wireless signal is available on the AT&T wireless
network. Upon receiving the Maintenance Signal, the Call Center stores
the status information but no direct action is taken.
In the event that a device senses it has a Hardware Error, a Warning
Message is displayed.
Medium
May have limited operation, depending on the failure
Yes. Message Button Flashes. Voice Message plays upon pressing the
Message Button.
Yes. A silent Maintenance Signal is sent to the Call Center by the Home
Communicator. Upon receiving the Maintenance Signal, the Call Center
prioritizes the response and contacts the Subscriber to verify the status
of their equipment.
In the event that a device senses it has a Software Error, a Warning
Message is displayed
Medium
May have limited operation, depending on the failure
Yes. Message Button Flashes. Voice Message plays upon pressing the
Message Button.
Yes. A silent Maintenance Signal is sent to the Call Center by the Home
Communicator. Upon receiving the Maintenance Signal, the Call Center
prioritizes the response and contacts the Subscriber to verify the status
of their equipment.