Philips Lifeline Instructions For Use Manual page 23

2. PRESS and HOLD DOWN the
Message button on the Home
Communicator. The Home
Communicator will beep and
announce: "Continue to hold the
Message button for AutoLearn. When
you are ready for Range Test, please
release the Message button."
Do not release the Message button until you get to Step 4 .
3. Continue to hold down the Message button on your Home
Communicator. With your other hand, press the wearable Help Button.
You will hear a long beep and a voice message saying: "Your Lifeline Help
Button is now auto-learned and ready to use." The Communicator will
also announce the four large digits that appear on the back of your Help
Button. This will indicate that the Help Button is working with the Home
Communicator. If the AutoLearn process fails, please contact Philips
Lifeline or your representative.
4. Repeat step 3 to reprogram all the other Help Buttons in your home.
Then, release the Message button on the Home Communicator. The
Home Communicator will announce: "Please press the flashing Message
button after you have completed the range test. Begin Signal Range
Test."
5. Press your Help Button. The Home Communicator will beep and the
light on your Help Button will flash green to indicate that the Home
Communicator has received the signal.
6. Move to other parts of your home and press your Help Button again.
Listen for the beep and check to see if the green light on the Button
is flashing.
23