Initializing The Ip Address Using 3Com Wireless Infrastructure Device Manager - 3Com 3CRWEASYG73 User Manual

Initializing the IP Address using 3Com Wireless Infrastructure Device Manager

3Com Corporation
After discovering the wireless bridge, you may use the 3Com Wireless
Infrastructure Device Manager (WIDMAN) to configure the IP address for the
wireless bridge. Once the IP Address has been assigned, use the HTTP Interface
to complete the configuration.
Use the following procedure to initialize the wireless bridge IP Address.
1. Open the 3Com Wireless Infrastructure Device Manager (WIDMAN), discover
the wireless bridge.
2. Double click the wireless bridge logo listed in the list box.
3. If the 3Com Wireless Infrastructure Device Manager (WIDMAN) found the
wireless bridge but could not be access it by it's IP, the 3Com Wireless
Infrastructure Device Manager (WIDMAN) will pop up a dialog for configuring
the wireless bridge IP address.
4. Enter an IP address and subnet mask then click OK.
5. After the wireless bridge reboots, verify the new IP Address. You can use the
ping network command from networked computers to test the new IP Address.
6. When the proper IP Address is set, use the HTTP Interface over the LAN to
complete configuration and manage operations.
Page 74