Additional Documentation; Symbols Used; Abbreviations; Extent Of Liabilities - Baxi EcoBlue Advance 13 Heat ErP Installation And Service Manual

Baxi EcoBlue Advance 13, 16, 19, 25, 30 Heat ErP Installation Manual

1.2 Additional Documentation

These Installation & Service Instructions must be read in conjunction with the Flue Accessories & Fitting Guide supplied in the Literature Pack.
Various timers, external controls, flue accessories, etc. are available as optional extras. Full details are contained in the relevant sales literature.

1.3 Symbols Used

In these instructions, various levels are employed to draw the user's attention to particular information. In so doing, we wish to safeguard the user's safety, prevent hazards and
guarantee correct operation of the appliance. Each level is accompanied by a warning triangle
DANGER
Risk of a dangerous situation causing serious physical injury.
WARNING
Risk of a dangerous situation causing slight physical injury.
CAUTION
Risk of material damage.
Signals important information .
Signals a referral to other instructions or other pages in the instructions.

1.4 Abbreviations

DHW: Domestic hot water
CH: Central heating
GB: Great Britain
IE: Ireland
BS: British standard
HHIC: Heating and Hotwater Industry Council
CSM: Chimney Sweep Mode
PU: Parameter Unit
PCB: Printed Circuit Board
Pn: Nominal output
Qn: Nominal heat input
Hs: Gross calorific value
page 8

1.5 Extent of Liabilities

1.5.1 Manufacturer's Liability
Our products are manufactured in compliance with the requirements of the various European applicable Directives. They are therefore delivered with
relevant documentation. In the interest of customers, we are continuously endeavouring to make improvements in product quality. All the specifications stated in this document are
therefore subject to change without notice.
The manufacturer will not accept any liability for loss, damage or injury arising as a result of:-
Failure to abide by the instructions on using the appliance.
Failure to regularly maintain the appliance, or faulty or inadequate maintenance of the appliance.
Failure to abide by the instructions on installing the appliance.
This company declares that no substances harmful to health are contained in the appliance or used during appliance manufacture.
The appliance is suitable only for installation in GB and IE and should be installed in accordance with the rules in force, and only used in a suitably ventilated location.
In GB, the installation must be carried out by a Gas Safe Registered Installer. It must be carried out in accordance with the current and relevant requirements of legislation and
guidance including the:-
Gas Safety (Installation & Use) Regulations.
The appropriate Building Regulations either The Building Regulations, The Building Regulations (Scotland), Building Regulations (Northern Ireland).
The Water Fittings Regulations or Water Byelaws in Scotland.
The Current I.E.E. Wiring Regulations.
Where no specific instructions are given, reference should be made to the relevant British Standard Code of Practice.
In IE, the installation must be carried out by a competent person and installed in accordance with the current edition of I.S. 813 "Domestic Gas Installations", the current Building
Regulations and reference should be made to the current ETCI rules for electrical installation.
Prior to commissioning all systems must be thoroughly flushed and treated after installation with inhibitor (see
appliance warranty.
Incorrect installation could invalidate the warranty and may lead to prosecution.
page 9
1.5.2 Installer's Responsibility
The installer is responsible for the installation and initial start up of the appliance. The installer must adhere to the following:
Read and follow the instructions given in the manuals provided with the appliance.
Carry out installation in compliance with the prevailing legislation and standards.
Ensure the system is flushed and inhibitor added.
6 of 55
http://interpart.partsarena.eu/System/DATA/Dx/DS1/installation/S219/...
section 5.2.6). Failure to do so will invalidate the
marking and all
23/01/2018, 11:44