Brother PE770 Service Manual page 23

Main unit
7
Front cover removal
1. Remove the screw 1 and the 3 screws 2.
2. Remove the hook 1 on the front cover, and then remove the hook 2 by
pushing the hook attachment section 2 on the rear cover.
*Key point
• Be careful not to damage the hooks 1 and 2 on the front
cover.
3. Remove the 2 bottom hooks 3 from the base plate while sliding the front
cover to the right.
4. Remove the flat cable 4 and the connector 5 from the main PCB
assembly, and then remove the front cover.
*Key point
• Move the lock of the connector 5 on the main PCB to the
upright position to release it, and then pull out the flat cable 4.
2 - 6
Main parts
1
2
1 2
3
4
5