Cord Holder Attachment - Brother PE770 Service Manual

Modules
9

Cord holder attachment

1. Pass the photo diode lead wire 1 through the cord holder 2.
2. Attach the cord holder 2 to the inner rotary hook bracket 3 with the
screw 1.
1
10
Inner rotary hook bracket assy. attachment
1. Align the inner rotary hook bracket assy 1 with the stopper plate block,
and hand start the screw 1
(Fully tighten after 4 - 18 "Inner rotary hook bracket position.")
1
11
Needle plate A ASSY assembly
1. Attach the F gear stopper plate 1 to the rear of the needle plate A 2 with
the screw 1.
*Key point
• Engage the positioning tab on the stopper plate with the
positioning hole on the needle plate A 2.
2. Attach the stopper plate 3 and then the needle plate B support plate 4 to
the rear of needle plate A 2 with the 2 screws 2.
*Key point
• Engage the positioning tab on the stopper plate with the
positioning hole on needle plate A.
1
2
Feed module
Screw, Bind
M2X3
0.29 — 0.49 N·m
Screw, Bind
M2.6X3
0.78 — 1.18 N·m
Screw, Bind
M2.6X3
0.57 — 1.78 N·m
1
Torque
Torque
4
2
Torque
1 3
2
1 1
3 1 1
2
3 - 57