Adjusting The Throttle Cable - Stihl FT 250 Instruction Manual

English
Mounting the control handle
4
3
1
2
Take out the screw (1) – the nut (2)
N
remains in the control handle (3).
Push the control handle onto the
N
handlebar (5) until the holes (6) line
up – the throttle trigger (4) must
point towards the gearbox.
Insert the screw (1) and tighten it
N
down firmly.
Fitting the throttle cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
12
Push the throttle cable (1) into the
N
retainer (2).
6

Adjusting the throttle cable

Check adjustment of throttle cable –
5 N
see chapter on "Adjusting the
Throttle Cable".
6
1
2
2
2
1
Adjusting the Throttle Cable
A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
positions.
Adjust the throttle cable only after the
unit is fully assembled – the control
handle must be in the normal operating
position.
Use a suitable tool to push the slide
N
to the end of the slot (see
illustration).
2
Press down the throttle trigger
N
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
1
FT 250