Fitting Padding - Stihl FT 250 Instruction Manual

Fitting Padding

Place the padding (1) against the
N
underside of the drive tube and fold
it up and around the drive tube.
2
Close the padding with the press
N
studs (2).
Rotate the padding until the press
N
studs are under the drive tube.
FT 250
Mounting the Deflector
Mounting the Limit Stop
2
1
WARNING
The limit stop (1) must be mounted on
the gearhead when you use a circular
saw blade.
Position the limit stop (1) on the
N
gearhead flange.
Fit the three M6 x 14 mm screws (2)
N
provided and tighten them down
firmly.
Mounting the Cutting
Attachment
Placing power tool on the ground
Shut off the engine.
N
Lay your power tool on its back so
N
that the cutting attachment
mounting face is pointing up.
Blocking the Shaft
The drive shaft must be blocked with the
stop pin to mount and remove the cutting
attachment. The stop pin is included with
the machine and is available as a
special accessory.
English
13